Details
INSTALLATION INFORMATION
READ ALL INSTRUCTIONS BEFORE INSTALLATION
NTK sensors are designed for use in automobiles only
Use the correct part number as listed in the application listing
Handling
DO NOT drop or use an oxygen sensor that has been dropped as this may have caused shock damage to the ceramic cell
DO NOT use any compounds on or around the sensor unless labeled as "oxygen sensor - friendly" products
DO NOT use impact wrench or conventional socket type wrench to install sensor
DO NOT allow lead wire to touch exhaust manifold or any other hot component
DO NOT expose this product to water, oil, windshield cleaner, anti-corrosion oil, grease, terminal cleaner, etc.
DO NOT use leaded fuels, silicone or metal based additives
DO NOT store under high temperature and/or high humidity conditions
Installation Instructions
Remove protector cap just prior to installation
If not already coated, apply (enclosed) anti-seize to oxygen sensor threads
Install sensor body ensuring lead wire is not twisted or bent
Install all sensors with new gasket supplied & torque to proper specs as below:
M18 sensors - Install finger tight then 1/2 -3/4 turn with wrench / O2 sensor socket 35ft. lbs.
M12 sensors - Install finger tight then 3/4 - 1 turn with wrench / O2 sensor socket 18ft. lbs.
Flanged applications - (where flange is NOT already installed on sensor)
Install flange to exhaust manifold first, then mount sensor in flange
(A copper gasket is bonded to the flange & no additional gasket is required)
Flanged applications - (where flange is already installedon sensor)
(It is important to use the supplied gasket before installing sensor)
Connect and route lead wire as originally installed
Manufacturer | NTK |
---|---|
Make | Toyota |
Model | RAV4 |
Year | 2009,2010,2011 |
Engine | 2.5L |
Trim | Any |
Write Your Own Review
Static CMS block displayed as additional tab.
You can insert any content here (text or HTML), e.g. info about returns and refunds.